Bosch GSB 14,4 VE-2-LI Notice Originale page 10

OBJ_BUCH-1982-002.book Page 10 Monday, October 13, 2014 2:33 PM
10 | English
Additional Safety and Working
Instructions
 Dusts from materials such as lead-containing coatings,
some wood types, minerals and metal can be harmful to
one's health and cause allergic reactions, lead to res-
piratory infections and/or cancer. Materials containing
asbestos may only be worked by specialists.
– Provide for good ventilation of the working place.
– It is recommended to wear a P2 filter-class respirator.
Observe the relevant regulations in your country for the mate-
rials to be worked.
 Before any work on the machine (e. g., maintenance,
tool change, etc.) as well as during transport and stor-
age, set the rotational direction switch to the centre
position. Unintentional actuation of the On/Off switch can
lead to injuries.
 The battery is supplied partially charged. To ensure full
battery capacity, completely charge the battery in the
battery charger before using for the first time.
 Read the operating instructions of the battery charger.
 Apply the power tool to the screw only when it is
switched off. Rotating tool inserts can slip off.
 Adjust the gear switch only when the machine is at a
complete stop.
 Always push the gear selector and turn the operating
mode selector switch through to the stop. Otherwise,
the machine can become damaged.
 In case of excessive loading, e. g., prolonged blocking
of the application tool, the electronics switch off the
power tool. After switching on again, the power tool
can be used again as intended for. In case of continued
overload, the power tool will switch off again in order
to prevent damage to the motor.
To save energy, only switch the power tool on when using it.
 Before performing any work, make sure that the auxil-
iary handle is firmly tightened. Loss of control can lead
to injury.
Rapid Shut-off
 The rapid shut-off feature enables better control of the
power tool. The power tool shuts off in case of sudden and
unexpected rotation of the power tool around the drilling
axis.
 The rapid shut-off feature is indicated by a flashing LED on
the power tool.
 To restart the machine, release the On/Off switch and
then actuate again.
 Rapid shut-off can trigger only when the power tool is
running at maximum operating speed and can rotate
freely around the drill bit axis. Choose a suitable work
position for this. Otherwise, rapid shut-off will not be en-
sured.
1 609 92A 0WS | (13.10.14)
Symbols
The following symbols are important for reading and under-
standing the operating instructions. Please take note of the
symbols and their meaning. The correct interpretation of the
symbols will help you to use the machine in a better and safer
manner.
Symbol Meaning
GSR 14,4 VE-2-LI/
GSR 18 VE-2-LI/
GSB 14,4 VE-2-LI/
GSB 18 VE-2-LI: Cordless screwdriver/
Combination cordless drill
Grey-marked area: Handle (insulated
gripping surface)
Article number
Read all safety warnings and all
instructions
Before any work on the machine itself,
remove the battery
Always wear ear protection
Movement direction
Reaction direction
Drilling and screwdriving
Impact drilling
Low speed
High speed
Switching On
Switching Off
Prohibited action
Bosch Power Tools