Publicité
Les langues disponibles
Les langues disponibles
Hard Floor Nozzle (depending on
model) (13)
• Efficient cleaning of hard floors
(wood, linoleum, etc)
Hard Floor Nozzle (depending on
model) (14)
• You can perform cleaning at any place like
corner or crevice since revolution is free.
Turbine Nozzle (depending on model) (15)
• Cleaning turbine brush nozzle.
• Press the button on the rear side of the
nozzle to separate the air cover.
• Use the dusting brush & crevice tool to
vacuum clean the brush and fan.
Using All Floor nozzle and mini
turbine nozzle
All Floor nozzle (depend on model) (16)
• The 2 position nozzle
This is equipped with a pedal which allows
you to alter its position according to the type
of floor to be cleaned.
• Carpet or rug position
Press the pedal (
• Hard floor position
Press the pedal (
rotating.
Mini turbine nozzle (optional) (17)
• Mini turbine is used for stairs and other hard
to reach places.
• To clean the mini turbine nozzle, remove
the nozzle cover:
Remove 2 screws on the bottom and take
mini turbine nozzle cover off as shown.
• Frequently clean and remove hair, string,
and lint build-up in the brush area.
Failure to do so could damage to mini
turbine nozzle.
Using accessory nozzles
Crevice Tool (depending on model) (18)
Crevice tool is for vacuuming in those
normally hard-to-reach places such as
reaching cobwebs or between the cushions
of a sofa.
), then brush will rotate
), then brush will stop
Upholstery Nozzle (depending on
model) (19)
Upholstery nozzle is for vacuuming uphol
stery, mattresses etc.
Dusting Brush (depending on model) (20)
Dusting brush is for vacuuming picture
frames, furniture frames, books and other
irregular surfaces.
NOTICE (21)
Use accessory in the sofa mode.
Emptying dust tank (22)
Cleaning the dust tank.
• Open the tank cap.
• Wash both parts with soft material.
Gently rinse both parts under a cold running tap.
Do not push the button when you carry the
!
vacuum cleaner. If push the button, it is
easy to detach the dust tank from the
vacuum cleaner.
Gently rinse both parts separately under a
cold running tap until the water runs clear.
Do not use detergent or a washing
machine or dishwasher.
Cleaning dust tank (23)
Push button and pull out dust tank.
Raise dust tank cap.
Dry fully in shade so that moisture is entirely
removed.
If suction power decreases after cleaning
!
dust tank, clean air filter and motor safety
Cleaning air filter and motor safety
filter (24)
If suction power is decreased after cleaning dust
tank, clean air filter and motor safety filter.
Air filter and motor safety filter are located at the
center of vacuum cleaner in the above figure.
• Open the air filter cover by pulling the air filter
cover lever and take out air filter.
• Separate the parts
• Wash air filter and motor safety filter with water.
• Do not wash filters with hot water.
- 18 -
Publicité
