Num'axes PIE1046 Guide D'utilisation page 29

Memory
Lens
LCD screen
PIR sensitivity
PIR detection distance
PIR detection angle
Capture modes
Photo resolution
Photo size for wireless transmission
Multi-shot
Picture files format
Video resolution
Video files format
Video length
Trigger time
Trigger interval
Camera ID
Time lapse
Cycle recording on SD card
Password
Operation power
Battery type
External DC
Stand-by current
Stand-by time
Auto power off
Interface
Mounting
Operating temperature
Storage temperature
Operation humidity
Watertightness
Dimensions
Weight
Application
12. Troubleshooting
12.1. The photos do not capture subject of interest
− Check the PIR sensitivity parameter setting. For warm environmental conditions, set the sensor sensitivity to
PIE1046 - Indice A –Septembre 2020
SD card (from 4GB up to 32GB – class 10 minimum)
F=3.0; FOV=100°; Auto IR-Cut-Remove (at night)
Built-in 2.4" TFT colour screen, RGB, 262k
3 levels: High / Medium / Low
20 m (65 ft.)
100°
Photo / Video / Photo + Video
8MP (3264x2448) / 12MP (4032x3024) / 24MP (5632x4224)
Small size (640x480) / Large size (1920x1440) /
Original size (8MP, 12MP or 24MP)
Programmable from 1 to 5 photos per trigger
JPEG
WVGA (848x480) / HD (1280x720) / FULL HD (1920x1080)
MOV
Programmable from 05 to 59 seconds
Between 0.35 and 0.4 second
Between 4 and 7 seconds
Programmable (12 digits/letters)
Programmable (ON / OFF)
Programmable (ON / OFF)
Programmable (ON / OFF)
Batteries: 9V - DC: 12V
12xAA (alkaline or rechargeable Ni-MH)
12V
0.135mA
Approximately 8 months
In Setup mode, the camera will automatically power off after 3 minutes
without any press on the keypad.
USB port / SD card slot / SIM card slot / DC port
Strap / Tripod
-25°C to +60°C
-30°C to +70°C
5% - 90%
IP66
148 x 116.5 x 75.5 mm
418 g (without batteries / 696 g (with batteries)
The PIE1046 trail camera can be remotely configured and triggered via the
free mobile application.
Android / iOS – Application's name: NumCam
29/76