Num'axes PIE1046 Guide D'utilisation page 26

Sendings/Day
SMS control
(remote control with
SMS commands)
Daily Report
SIM PIN
PIE1046 - Indice A –Septembre 2020
Example: If Multi-shot is set on 5 photos per trigger; and you choose 1
rd
3 photo in "Multi-shot send", then the 1
photos will be sent out to your e-mail(s) or FTP account.
NOTE 1: If the only available network around the camera is 2G, only the 1
size 640x480) will be sent.
NOTE 2: If the only available network around the camera is 3G, only the 1
size 640x480 or 1920x1440) will be sent.
NOTE 3: With 4G network available, 1
1920x1440) can all be sent. If you selected original size photos (8/12/24MP), only
2 photos can be sent with 4G network.
GENERAL NOTE:
− The camera will send photos to the preset phone numbers via MMS only.
− The camera will send photos to the preset e-mail addresses via MMS only if
the SMTP parameter is OFF.
− The camera will send photos/videos to the preset e-mail addresses via SMTP
only if the SMTP is configured.
Unlimited / 01 – 99
Example: if you select 50, then the camera will only send photos/videos 50 times
every day.
Each time, the camera will send to all entered phones/e-mails/FTP accounts. The rest
of the photos/videos taken that day will not be sent but they will be stored in the SD
card.
1 time/day / Permanent
− 1 time/day (suggested for AA battery power): the camera will only be able to
change and save the setups remotely when the camera will send the daily
report every day.
− Permanent (suggested when using a power adaptor as this option will
consume huge battery power): the camera 4G module is in stand-by all the
time; so the camera setups can be changed and saved whenever you send the
remote SMS setup commands.
OFF / ON
If you want to receive a daily report, select ON to enter then set up a time (HH:MM)
when you want the camera to send it to you.
Contents of the daily report: device IMEI number, CSQ (signal strength): 0-31, camera
ID, temperature, date and time, battery left volume, SD card info, total pictures taken
by camera, send times.
You can ignore the description below if your SIM card has been already activated.
− During the signal search in SETUP mode, the camera will check if the inserted
SIM card is activated.
− After the signal search, the message "Pls input PIN-Code" will appear on the
LCD screen if your SIM card is not activated (the message will not appear if
your SIM card is already activated).
− The "SIM PIN" setting will become configurable in the "4G" page of the menu.
− Enter the PIN code of your SIM card in the "SIM PIN" setting. The camera will
automatically power off. When you will restart it, the camera will activate the
SIM card automatically during the signal search.
NOTE:
− The message "Pls input PIN-Code" will pop up again if the wrong PIN code is
entered.
st rd
photo and 3 photo taken from the 5
st th
photo to 5 photo (in size 640x480 or
st
photo and
st
photo (in
st
photo (in
26/76