Wiko BLOOM 2 Guide De L'utilisateur page 6

~ Installing Memory Card
Your phones takes a MicroSD memory card of up to
64 GB.
Insert the microSD memory card following the diagram
below.
~ Charging the Battery
A flashing red light indicates that the battery level is
very low : the battery should be recharged because,
if the level is too low, it may shorten the life of the
battery.
Connect the charger to a power outlet and the micro
USB connector to the phone's USB port.
The phone's status indicator changes to red, indicating
that the device is charging.
Once the phone has finished charging, the status
indicator changes to green and you should unplug
the charger.
For more information, refer to the Safety Informa-
tion section.
~ Turning the Phone On and Off
To turn the phone on, press on the ON/OFF button and
hold it down until the phone begins to vibrate.
If your SIM card is locked, you must enter the correct
PIN code to unlock the SIM card when the phone is
powered up. Your PIN is supplied by your operator;
if you did not receive it or have lost it, please contact
them.
When the PIN is entered incorrectly three times, the
mobile phone is blocked and has to be unblocked
using your PUK (this is supplied with the SIM card;
if this is not the case, you should contact your phone
operator).
To turn the phone off, press and hold the ON-OFF but-
ton until the menu opens, then press on Switch Off .
Now press OK to confirm.
The phone vibrates when it is shut down completely.