Party Light & Sound PARTY-SINGTOGETHER Manuel D'utilisation page 4

Bluetooth Pairing
1. Power the speaker ON. A tone will be heard and the LED indicator will quickly flash BLUE.
2. Enable the Bluetooth search function on your mobile device. Select "PARTY-SINGTOGETHER" in the list of
found devices.
3. After successful pairing, a tone will be heard and the LED indicator will slowly flash BLUE .
Use with Wired Device
Insert one connector of a 3.5 mm auxiliary cable into the 3.5mm auxiliary input port on the top of the speaker.
Insert the other connector into the headphone jack of your media-playing device. The LED indicator will light
BLUE when an AUX cable is connected.
All Bluetooth pairings will be disconnected while the 3.5mm AUX jack is connected.
Operation of the LED light effect
Press the [LED] button to cycle through the light modes.
Specifications
Input voltage
USB output voltage
Built-in battery
Play time at average volume
Signal-to-noise ratio
Frequency response
BT frequency
Bluetooth version
Bluetooth mode
Max. RF transmission power
Dimensions
Height of the stand
Weight
Correct disposal of the product
This marking indicates that this product should not be disposed with other household wastes throughout the EU. To
prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to
promote the sustainable reuse of material resources. To return your used device, please use the return and collection
systems or contact the retailer where the product was purchased. They can take this product for environmental safe
recycling.
4
5V�� 1A via supplied USB charging lead
5V�� 0.5A
Lithium 3.7V�� 1500mAh
2 hours
>65dB
80Hz - 18kHz
2402-2480MHz
5.0
HSP, HFP, A2D
2.09dBm
195 x 208 x 213mm
35-157cm
2.08kg
EN