Publicité
Les langues disponibles
Les langues disponibles
EN
Please note: The USB port can provide a current of 0.5A max under a voltage of 5V to charge your smartphone
or any other connected device
1. PRIOR to using the unit for the first time, please charge fully the battery
2. Charge the battery regularly after each use. Don't wait until it is discharged!
3. DON'T allow the battery to discharge completely, otherwise it will lose 20% of its capacity or
even be totally damaged!
If the voltage becomes too low, the internal circuits are not powered anymore and it will become
impossible to recharge the battery!
4. If you don't use the unit for a longer period of time, it is recommended to charge it at 40% of
its capacity and check/charge it once per month.
We cannot be held responsible for damaged batteries further to the non-observance of these
RECOMMENDATIONS FOR BATTERIES
This symbol indicates that used batteries should not be disposed of with household waste but deposed correctly in ac-
cordance with your local regulations. Batteries shall not be exposed to excessive heat such as sunshine, fire or the like.
When the internal batteries are not to be used, remove them to avoid damage caused by battery leakage or corrosion.
ATTENTION: Danger of explosion if battery is incorrectly placed. Only replace by the same or equivalent type.
Location of Controls
1. Mic Stand Holder
2. Handle
3. Light effect switch
4. LED indicator
5. ON/OFF switch
6. Micro-USB Charging Port
7. 3.5mm Auxiliary Input Port
8. Mic 1 Input
9. Mic 2 Input
10. Mic Volume Knob
11. Mic Echo Knob
12. Master Volume Knob
13. TF card slot
14. USB slot
15. Go back to the previous song
16. Play/pause
17. Go forward to the next song
Using the speaker
Flip the on/off switch to the ON position to switch the speaker on. A tone will be heard, and the speaker will
enter into Bluetooth pairing mode. The speaker will automatically re-connect to any nearby, previously-paired
device when the Bluetooth function is enabled. Flip the on/off switch to the OFF position to switch the speaker
off.
Use with a TF card
Connect your TF card to the SD input (13). The speaker will automatically select the SD input. Select a file via
the backward (15) or forward (17) buttons. Press the PLAY/PAUSE button (16) to start playing the file.
Use with a USB stick
Connect your USB stick to the USB input (14). The speaker will automatically select the USB input. Select a file
via the backward (15) or forward (17) buttons. Press the PLAY/PAUSE button (16) to start playing the file.
Please note: If both inputs, SD and USB, are connected, the player will select automatically the latest connected input source.
IMPORTANT NOTE ON LITHIUM-ION BATTERIES
** BATTERIES ARE NOT COVERED BY THE WARRANTY **
basic rules.
1
2
3
4
5
6
7
8
9
10
15
11
12
13
SD
16
17
14
USB
3
Publicité
