Rf Remote Control - Zephyr Monsoon II AK9334BS Guide D'utilisation, D'entretien Et D'installation

Features & Controls

RF Remote Control

FCC Caution
To assure continued compliance, any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate this equipment. (Example -
use only shielded interface cables when connecting to computer or peripheral device. This device
complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions. (1)
This device may not cause harmful interference, and (2) This device must accept any interference
received, including interference that may cause undesired operation.
Synchronization
To create a unique link between your liner and remote control please follow these steps.
1. With liner off, press and hold the "lights" button on the liner until the letter "F" shows on the display
screen.
2. Press the "lights" button on the remote, the lights on the liner will turn on and synchronization is
complete.
RF Remote Control Functions
Blower On/
Blower On/
1
2
Speed Selection
Power Off
3 4
Lights Low/High/Off
5 Min Delay Off
22
Blower On / Speed Selection
1
Press to power on blower and cycle through all six blower speeds.
2 Blower On / Power Off
By pressing , the blowers will power on at the last speed setting. Press
again and the entire hood will power off, including lights.
Delay Off
3
By pressing , the blower and lights will enter Delay Off mode. A dot will
appear in the lower right corner of the hood display
is on. The blower will change to speed 1 and shut down after 5 minutes.
Lights Low/High/Off
4
Switch lights to Low by pressing
Monsoon II Use, Care, and Installation Guide
M O N S O O N I I
indicating the function
once, again to High and again to switch Off.
P R O
I N S E R T