Operation - Inventum IVW6015A Manuel D'utilisation

Note:
For the programs "Auto intensive" , "Auto basic" and "Auto delicate", the appliance automatically adjusts
the washing time, the temperature and the amount of water based on the soil level of the dishes.
• The program duration can change based on the amount of dishes, the water temperature, the ambient
temperature and selected additional functions.
• The eco program is suitable to clean normally soiled dishes. It is the most efficient program because of the
combined energy and water consumption and it complies with the EU ecodesign legislation.
Note:
The energy consumption values of the eco program can differ according to regulations 10/16/2010
and 1059/2010. The table complies with regulations 2019/2022 and 2017/2022.
• When the appliance is used according to the instructions of the manufacturer, washing dishes in a household
dishwasher usually consumes less energy and water during the use phase compared to hand-washing dishes.
• Short programs do not include drying.
• Only use powder detergent when you choose a short program.
• To assist drying, we recommend opening the door 15 cm after a cycle is complete.
5

Operation

PREPARING FOR OPERATION
1. Do a check if the electricity and the water supply connections of the appliance match the values indicated in the
installation instructions.
2. Remove all packaging material inside the appliance.
3. Fill the salt reservoir. Refer to section
4. Fill the rinse aid reservoir. Refer to section
FILLING THE SALT RESERVOIR
For a good result the appliance needs soft (less calcareous) water. Salt is used to soften the water and it prevents
white lime residues on your dishes and the interior of the appliance.
Caution:
Only use salt that is suitable for a dishwasher. Do not use table salt.
Note:
Fill the salt reservoir when the salt indicator on the control panel is on.
1. Remove the lower basket.
2. Turn the cap (A) of the salt reservoir counter-clockwise to remove it.
3. Fill the salt reservoir with water.
Note:
You only have to fill the salt reservoir with water before first use of the appliance.
4. Put a funnel in the opening of the salt reservoir.
5. Fill the reservoir with salt until the overflow level.
6. Install the cap of the salt reservoir.
Caution:
Remove any spilled salt immediately and run a full program to prevent corrosion of the appliance.
'Filling the salt reservoir' .
'Filling the rinse aid reservoir'
.
English
(Figure 3)
(Figure 4)
(Figure 5)
• 41