RedMax HBZ2601 Mode D'emploi page 36

F13
F14
36
English
9. Maintenance
■ AIR INLET SCREEN
IMPORTANT
• Blowing air is taken in from the air inlet screen.
When air flow has dropped down during operation,
stop the engine and inspect the air inlet screen for
blocking by obstacles.
• Note that failure to remove any such obstacles may
result in the engine becoming overheated and
damaged.
WARNING
Never use the blower without the screen at the air
intake of the blower. Before each use, check that,
the screw (1) is securely tightened and is free from
any damage.
(1) Screw (2) Air inlet screen
■ PROCEDURES TO BE PERFORMED AFTER
EVERY 100 HOURS OF USE
• Remove the muffler, insert a screwdriver into the
vent, and wipe away any carbon buildup. Wipe away
any carbon buildup on the muffler exhaust vent and
cylinder exhaust port at the same time.
• Tighten all screws, bolts, and fittings.
10. Storage
BEFORE STORING THE BLOWER:
1. Drain a fuel tank and push the primer bulb until it
becomes empty of fuel.
2 .Remove the spark plug and drop a spoonful of 2-
cycle oil into the cylider. Crank the engine several
time and install the spark plug.
3. Store unit in a dry, dust free place, out of the reach
of children.
11. Disposal
• When disposing your machine, fuel or oil for the
machine, be sure to allow your local regulations.
12. Optional vacuum kit usage
• See the operating instructions included with the
vacuum kit.