Draining And Cleaning The Tank; Accessories - Solo 451 Instructions D'emploi

12.6 Draining and cleaning the tank

For cleaning purposes, the tank can be fully
drained into a suitable container via the supply
hose.
For this, the engine must be cooled down.
Position the equipment onto a stable higher
support, so that the spray medium can drain into a
suitable container below.
Above the container, pull the supply hose from the
shut-off valve.
If required, tip the equipment slightly to drain the
tank completely.
Ensure that the spray medium does not run over
the equipment (especially the engine), but drains
directly into the suitable container.
Fig. 12
Dispose of residual spray medium correctly at
disposal sites licensed for specialised waste.
Please obtain the following practical accessories from your SOLO Dealer:

Accessories

13.
ULV-nozzle
Double Nozzle
ULV Dosage Selector
Attachment for
Liquid Booster Pump
Extension Tube 60 cm
SOLO plant protection unit cleaner
ULV-Nozzle with ULV dosage selector for application of minute
amounts of high concentrated substances (ultra-low volume
application technique), with dosage accuracy.
To broaden spray stream or to treat two rows simultaneously.
For application of minute amounts of high concentrated substances
(ultra-low volume application technique), with dosage accuracy.
Increases formula output and application range.
Multiple Combinations possible with use of Liquid Booster Pump
Empty the spray medium tank daily after work and
flush thoroughly with water.
Observe cleaning instructions supplied with the
herbicide/fungicide.
After cleaning, let the spray medium container dry
in an open state.
Fig. 13
Occasionally clean the strainer inside the filler
neck, the strainer in the accessory set and all parts
in contact with the medium, with water and a soft
brush.
in a metering bottle 500 ml
Operation hints ; Accessories
Part No.
49 00 479
49 00 137
49 00 169
44 00 235
49 00 333
49 00 600
ENGLISH 15