Removing The Grease Filters; Replacing The Carbon Filter; Changing The Light Bulbs - ETNA TO250 Mode D'emploi

MAINTENANCE
Grease filters
Carbon filter
Lighting

Removing the grease filters

Switch off the electricity! Remove the plug from the socket or switch
the electricity off at the mains. Pull the grease filter towards you and tilt
it downwards at the front.

Replacing the carbon filter

The carbon filter must always be used if the cooker hood is not ducted.
1. Remove the grease filters.
2. Attach the carbon filters to the motor.
3. Replace the filter grids in the extractor hood.
Note:
• Saturation of the activated charcoal will eventually occur after more
or less prolonged use, depending on the type of cooking and how
frequently the grease filter is cleaned.
• In all cases it is necessary to replace the cartridge at least every
four months.
• DO NOT wash or reuse the carbon filter. Saturated carbon is not
environmentally friendly, change the filter regularly.

Changing the light bulbs

T250/300
• Remove the grease filters. This gives access to the light bulbs.
• Unscrew the bulb from the fitting and replace it with a bulb
matching the wattage stated at the inside of the hood.
T400
• Remove the lamp cover.
• Replace the halogen light bulb with a replacement bulb with a
maximum output power of 20 Watts.
• Re-close the lamp cover.
GB 9