KitchenAid 740-0780 Instructions D'installation Et Guide D'utilisation Et D'entretien page 15

Change Grill Main Burner Valve Orifices
1. Remove the grates and flame tamers.
2. Remove the two screws and clip that hold the burner in
place. Set the screws and clip aside.
3. Remove the burner from the grill by lifting the burner out.
4. Use a 6 mm socket and wrench or 6 mm nut driver to
remove the brass orifice from the end of gas valve. The
main NG burner orifice is located behind the LP orifice, so
no additional orifice needs to be installed.
A
A. Main burner orifice
IMPORTANT: Check that the orifice is properly installed
inside of the gas valve.
5. Reinsert the burner and reattach using the screw and clip
previously removed. Repeat the procedure for each main
burner.
6. Position the igniters so they are ¼" (6.0 mm) away from
each burner.
Change the Rotisserie Burner Orifice
1. Use a screwdriver to remove the two screws from the
rotisserie burner heat shield. Remove the heat shield.
2. Remove the access cover at the back of the grill by
removing the 6 screws at the back of firebox.
3. Using a Phillips screwdriver and remove the screw holding
the spider guard to the burner.
4. Use 24 mm wrench to remove the orifice nut.
A
15
A. Wind baffle
A
A. Access cover
A. Orifice Nut
A