Trouble Shooting - Josef Kihlberg a.560PN22 Mode D'emploi

Josef Kihlberg a.560PN22
KUDA PACKAGING
8 8
Before all trouble shooting tasks on
the stapler it must first be
disconnected from the air supply.
FAULT
No staples when firing the tool.
Bad clinch
Jammed staple in the nozzle.
SERVIS A NAHRADNÍ DÍLY
12
www.kuda-packaging.com

TROUBLE SHOOTING

TROUBLE SHOOTING
– Check that the right type of staples is being used
and moves easily.
– Always use Josef Kihlberg original staples.
– Check if the feeder spring is not defective. If
necessary replace.
– Check if the staple pusher is not defective. If
necessary replace.
– Clean the staple track.
– Air pressure too low. Secure that working pressure
is as recommend, see chapter 6.6.
– Check if the right leg length is used and the sta-
pler is right adjusted, see chapter 6.1.
– Has the tool been used without oil? Provide lubri-
cation, see chapter 5.2.
– Remove the defective staple, see chapter 7.2.
+420 607 237 237
info@kuda-packaging.com
ELIMINATION
servis@josef-kihlberg.eu
06.14