Assembly; Operation - PrimAster PMAKS Pro Manuel D'utilisation

EN ENGLISH
• Injury to the skin caused by contact with lubricants
• Parts ejected from the saw chain (cutting/injection
hazards)
• Unforeseen, abrupt movement, or kickback of the
guide bar (cutting hazards)"
Risk Reduction
• It has been reported that vibrations from handheld
tools may contribute to a condition called Raynaud's
Syndrome in certain individuals. Symptoms may inclu-
de tingling, numbness, and blanching of the fingers,
usually apparent upon exposure to cold. Hereditary
factors, exposure to cold and dampness, diet, smoking
and work practices are all thought to contribute to the
development of these symptoms. There are measures
that can be taken by the operator to possibly reduce
the effects of vibration:
• Keep your body warm in cold weather. When operating
the unit wear gloves to keep the hands and wrists

ASSEMBLY

Assembling saw chain and guide bar
WARNING
If any parts are damaged or missing do not operate
the machine until the parts are replaced. Failure to
heed this warning could result in serious personal
injury.
Make sure to remove the battery. Wear protective gloves.
WARNING
The saw chain is sharp. Always wear protective
gloves when performing maintenance to the chain.
Adjusting the chain tension
Remove the battery pack before you do any work on the
chain saw.

OPERATION

Adding the chain lubricating oil
WARNING
Never work without chain lubricant. If the saw
chain is running without lubricant, the guide bar
and the saw chain can be damaged. It is essential to
frequently check the oil level in the oil level gauge
and before starting to use the chain saw.
56
warm.
• After each period of operation, exercise to increase
blood circulation.
• Take frequent work breaks. Limit the amount of expo-
sure per day.
• Protective gloves available from professional chain saw
retailers are designed specifically for chain saw use
which give protection, good grip and also reduce the
effect of handle vibration. These gloves should comply
with EN 381-7 and must be CE marked.
If you experience any of the symptoms of this condition,
immediately discontinue use and see your doctor.
WARNING
Injuries may be caused, or aggravated, by
prolonged use of a tool. When using any tool for
prolonged periods, ensure you take regular breaks.
To increase the chain tension, turn the chain tensioning
screw clockwise and check the chain tension frequently.
To reduce the chain tension, turn the chain tensioning
screw counterclockwise and check the chain tension
frequently.
The chain tension is correct when the gap between
the cutter in the chain and the bar is about 6,8 mm.
Pull the chain in the middle of the lower side of the
bar downwards (away from the bar) and measure the
distance between the bar and the chain cutters.Tighten
the bar mounting nuts by turning it counter clockwise.
Note Do not over-tension the chain - excess tension will
cause excessive wear and will reduce the life of the chain
and could damage the bar. New chains could stretch
and loosen during initial use. Remove battery pack and
check chain tension frequently during the first two hours
of use.The temperature of the chain increases during
normal operation causing the chain to stretch. Check the
chain tension frequently and adjust as required. A chain
tensioned while warm may be too tight upon cooling.
Make sure that the chain tension is correctly adjusted as
specified in these instructions.
Keep the reservoir more than ¼ full to ensure sufficient oil
is available for the job.
Note It is recommended to use a vegetable based chain
oil when pruning trees. Mineral oil may harm trees. Never
use waste oil automotive oil, or very thick oils. These
could damage the chain saw.Clear surface around the oil
cap to prevent contamination.