Care & Cleaning - Sage the Bakery Boss BEM825 Guide Rapide

Care & Cleaning
Motor head and mixer base
Do not wash or immerse the mixer motor head
or mixer base in water. Do not allow water or
other liquids to enter the gear system, as this
may result in damage.
Wipe clean with a soft, damp cloth then dry
thoroughly. Wipe any excess food particles from
the power cord.
Cleaning agents
Do not use abrasive scouring pads or cleaners
on the mixing bowl, flat beater, dough hook or
whisk, as they may scratch the surface. Use
only warm soapy water with a soft cloth.
Also do not soak attachments for extended
periods of time, for example several hours or
overnight, as this may damage the finish.
Bowl and attachments
Wash the bowl and attachments (beater,
scraper beater, whisk and dough hook) with
warm soapy water and a soft cloth or a soft
bristled brush. Rinse and dry thoroughly.
Avoid abrasive scouring pads or cleaners,
as they may damage the surfaces.
Dishwasher
Stainless Bowl, Beater, Scraper Beater &
Dough Hook can be washed in the dishwasher
on a standard wash cycle. Place Scraper beater
on the top shelf only. Sage
washing only of the Glass Bowl and Whisk.
SEM825_UG5_COMBINED_A19.indb 9
recommends hand
®
Troubleshooting
Motor head safety cut-off
The mixer is equipped with a motor head safety
cut-off. If the mixer head is lifted up at any time
while the mixer motor is switched on, the safety
cut-off will automatically switch the motor off
and set the mixer into standby mode.
To restart the motor within 5 minutes, lower the
mixer head into the horizontal (closed) position,
and turn the dial away then back to the required
speed setting. This will resume mixing and the
timer will resume counting.
To restart the motor after 5 minutes or more,
lower the mixer head and turn the dial to OFF
then back to the required speed.
The timer will start from 0.
To turn the mixer off (instead of restarting), turn
the dial to OFF, and unplug from the wall.
EN
9
6/8/19 3:50 pm