Makita BPT350 Manuel D'instruction page 5

FUNCTIONAL DESCRIPTION
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before adjusting or
checking function on the tool.
Installing or removing battery cartridge
1
2
007725
Always switch off the tool before insertion or
•
removal of the battery cartridge.
To remove the battery cartridge, withdraw it from
•
the tool while sliding the button on the front of the
cartridge.
To insert the battery cartridge, align the tongue on
•
the battery cartridge with the groove in the housing
and slip it into place. Always insert it all the way
until it locks in place with a little click. If you can
see the red part on the upper side of the button, it
is not locked completely. Insert it fully until the red
part cannot be seen. If not, it may accidentally fall
out of the tool, causing injury to you or someone
around you.
Do not use force when inserting the battery
•
cartridge. If the cartridge does not slide in easily, it
is not being inserted correctly.
Safety system
WARNING:
Make sure all safety systems are in working order
•
before operation. Failure to do so may cause
personal injuries.
1
007726
Test safety systems for possible faulty operation before
pin-nailing as follows.
1. Red part
2. Button
3. Battery cartridge
3
1. Trigger
2. Lever
2
1. Make sure that the tool is not loaded with pin nails
before the test.
2. Pull the sliding door of the magazine toward
yourself.
007727
3. The tool accidentally operates if only the trigger is
pulled although the lever is not pulled.
4. The tool does not operate when the trigger is
pulled with the lever pulled.
In case of 3 and 4 above, the safety systems are faulty.
Trigger and lever
WARNING:
Always be sure that the tool is switched off before
•
inserting the battery cartridge on the tool.
007728
The tool is provided with lever as a safety system in
addition to the usual trigger.
To fire pin-nails, first pull the lever and then pull the
trigger.
007729
5
1. Sliding door
1
1. Lever
1
1. Trigger
1