Toolland FT90N Mode D'emploi page 5

Open the gas flow by turning the lever of the pressure regulator toward the marking.
Ignition of the Gas Heater
 Fully press the button and turn in an anticlockwise direction.
 Hold the button pressed for 20 seconds. Repeat this operation until the pilot light is lit. The pilot light is
located on the lower part of the protection grid (where the ignition sparks are generated). Keep the button
pressed for another 10 seconds after the pilot light is lit. Repeat the steps above if the pilot light dies out
when releasing the button.
position 1
start and max. heating
9. Thermostatic Ignition
Prior to using the gas heater for the first time or after the gas heater has been stored for a long time,
we recommend, with the pressure regulator closed, repeatedly pressing the buttons a few times.
Open the gas flow by turning the lever of the pressure regulator toward the marking.
Switching On the Gas Heater
 Fully turn the thermostat button in an anticlockwise direction until it reaches its maximum position.
 Fully press the button for 15 seconds, and then press the
 The pilot light will burn. Repeat the steps above if the pilot light dies out.
 Keep pressing the
thermostat button at its maximum position for 10 minutes. When the room has reached the ideal
temperature, turn the thermostat button in the desired position.
10. Cleaning and Maintenance
In the unlikely event of technical problems or should you need spare parts, please contact your dealer.
 Periodic maintenance must be done by a qualified technician only.
 We recommend servicing your gas heater every two years by a qualified technician.
 Regularly check the pilot light which must burn steadily.
 Check if the gas hose must be replaced. If so, contact your dealer for a new hose and connect as described
in chapter 6. Starting the Gas Heater.
 We recommend cleaning your gas heater only with a closed pressure regulator, after the gas heater has
cooled down completely, and using non-abrasive cleaning agents.
 Store an unused gas heater in a dry and dust-free room, covered with a plastic sheet or cloth.
11. Troubleshooting
The gas heater does not switch on.
 Check if the gas cylinder is filled with gas and if the pressure regulator is correctly connected and opened.
 Make sure the gas hose is connected. Please follow the instructions correctly.
 Presence of air in the gas cylinder. Keep pressing the button until the pilot light burns and the gas heater is
switched on. Next, turn the thermostat button to the maximum position.
 The gas cylinder has been exposed to low temperatures. Apply hot and damp cloths to the upper part of the
gas cylinder to enhance the gasification and the normal gas output.
V. 03 – 18/10/2016
button for 20 seconds to allow the thermocouple to heat. Release and leave the
FT90N
position 2
medium
button 2 or 3 times.
5
position 3
minimum
©Velleman nv