Maintenance; Troubleshooting - HTC PS 30 Manuel D'utilisation

3. Pull the bag up from the bag holder and put it around
the container.
4. Tighten a strap around the bag and the container to
secure the bag to the container.
Introduction
When cleaning and doing service on the product,
disconnect the product from the dust extractor.
• The product must be cleaned before the product is
moved from the work area.
• All other equipment must be seen as contaminated.

Troubleshooting

Issue
Unsatisfactory suction
6
5. Pull the dust bag over the bag holder.
6. Close the bottom of the dust bag with a cable tie.

Maintenance

• Use a cleaning room if it is possible.
• Correct personal protective equipment must be
used.
• All parts that are contaminated must be correctly
discarded in plastic bags after maintenance is done.
Refer to unhealthy dust such as silica dust.
Troubleshooting
Cause
Damages on the hose
The top cover is loose
Dirt in the flap to the dust bag
Sealing is defective
The toggle latches are loose
Solution
Replace the hose
Adjust the top cover
Clean the flap
WARNING: Use
personal protective
equipment
Replace the sealing
Tighten the toggle latches
955 - 003 - 11.12.2018