Installation; Operation - HTC PS 30 Manuel D'utilisation

WARNING: Do not make holes in the
Longopac bag. Risk of dust dispersion.
General
When unpacking the product, check for damage and
that the accessories are included:
Introduction
The pre-separator must be attached to a dust extractor
with the correct capacity.
To connect the product
Connect the appropriate pre-separator to the grinder
and dust extractor according to the illustration. The
outlet on the top should be connected to the dust
extractor (A) and the inlet on the front should be
connected to the grinder (B). On the PS 30 the shorter
hose length provided with the pre-separator should be
used between the pre-separator and dust extractor.
A
To assemble a new Longopac dust
bag
WARNING: Always clean the prefilter before
change of bag collection system.
Note: The dust extractor has Longopac system.
955 - 003 - 11.12.2018

Installation

•
If any of the accessories are missing, please contact
your local distributor or a sales representative.

Operation

1. Put the dust bag in the holder.
B
2. Attach the dust bag holder to the container by
Hose with end fittings
twisting it on to the holding pins.
5