Table Des Matières; Introduction; Product Description; Intended Use - HTC PS 30 Manuel D'utilisation

Introduction..................................................................... 2
Safety..............................................................................4
Installation.......................................................................5
Operation........................................................................ 5

Product description

When the dust extractor is started, dust laden air is
sucked through the inlet valve at high speed through the
suction hose. The air is slowed down by the cyclone and
large dust particles are separated. Fine dust particles
continue to through the hose to the dust extractor. The
separated dust accumulates in the cyclone. When the
dust extractor is switched off, the dust falls through the
bottom flap into the plastic dust bag.
2
Contents
Maintenance................................................................... 6
Troubleshooting.............................................................. 6
Technical data................................................................ 7
EC Declaration of Conformity......................................... 8

Introduction

The separated dust accumulates in the cyclone. When
the dust extractor is switched off, the dust falls through
the bottom flap into the plastic dust bag.

Intended use

The pre-separator PS 30 is intended for commercial
use.
The product is intended for pre-separating dry, non-
combustible dust.
955 - 003 - 11.12.2018