Marq GESTURE SPOT 100 Guide D'utilisation page 5

Setup
Note: Items not listed under the Introduction > Box Contents are sold separately.
Power Information
Before connecting the fixture to a power outlet, make sure the power cable is not crimped or
damaged. Also, make sure the power outlet's voltage is within the range stated on this product (on
its housing or decal).
Before cleaning or replacing the fuse, disconnect Gesture Spot 100 from its power source. Use a
screwdriver or other tool to remove the compartment (do not pull it out by the tab only). Replace the
fuse only with a new fuse with the same rating (F2A, 250 V).
Mounting/Rigging
Place or mount this fixture in a vertical position only (right-
side-up or upside-down). Placing or mounting it in a
sideways position can affect motor operation.
Standing
Place the fixture on a flat, stable surface. Make sure all
cables are secured and placed so that no one will trip
over them.
Suspended
1 2
Optional: Follow these steps
to use the hanging bracket
Clamp (not included)
(included) for mounting the
fixture to a truss.
Hanging Bracket
3 4 5
(tighten until
secure)
1/4-turn
1/4-turn
5