Rear Panel; Front Panel - Marq GESTURE SPOT 100 Guide D'utilisation

Features

Rear Panel

1. Power In: Use a standard power cable
(included) to connect this input to a power
outlet.
2. Fuse: This compartment holds the fuse.
Before cleaning or replacing the fuse,
disconnect Gesture Spot 100 from its
power source. Use a screwdriver or other
tool to remove the compartment (do not
pull it out by the tab only). Replace the fuse
only with a new fuse with the same rating
(F2A, 250 V).
3. Power Out: Use a standard power cable to connect this output to an additional fixture. This
connection will supply power to the additional fixture when this one is connected a power outlet.
Please see Setup > Linking > Power
Note: On models sold in the USA, this will be a standard "Edison" (NEMA
models, this will be a standard IEC connection.
4. DMX In: Use a standard 3-pin DMX cable to connect this input (A) to your DMX controller or (B)
to another fixture that will pass DMX data through it to this one. Gesture Spot 100 receives DMX
data over this connection. Please see
multiple fixtures.
5. DMX Out: Use a standard 3-pin DMX cable to connect this output to an additional fixture.
Gesture Spot 100 sends its data to an additional fixture over this connection. Please see
Linking > DMX

Front Panel

6. Display: This display shows messages and
values indicating the fixture's current status.
7. Menu: Press this button to access Gesture
Spot 100's menu.
8. Up: Press this button to select the next-
highest menu option or to increase the
value by 1.
9. Down: Press this button to select the next-lowest menu option or to decrease the value by 1.
10. Enter: Press this to confirm your current selection or value.
4
for information about linking multiple fixtures.
3
for information about linking multiple fixtures.
Setup > Linking > DMX
1
5
2
4
®
) connection. On other
for information about linking
6
7 8 9
10
Setup >