Sony AV RECEIVER XAV-1500 Mode D'emploi page 14

Installation
Removing the mounting sleeve
Before installing the unit, remove the mounting
sleeve  from the unit.
1
Insert both release keys  until they click,
and pull down the mounting sleeve , then
pull up the unit to separate.


Face the hook inwards.
Mounting the unit in the dashboard
• Before installing, make sure the catches on both
sides of the mounting sleeve  are bent inwards
3.5 mm ( 5 / in).
32
• For Japanese cars, see "Mounting the unit in a
Japanese car" (page 14).
1 Position the mounting sleeve  inside the
dashboard, then bend the claws outward
for a tight fit.

14
GB
Larger than
Catch
182 mm (7 1 /
Larger than
111 mm (4 3 / in)
8
2
Mount the unit onto the mounting sleeve
.

Notes
• If the catches are straight or bent outwards, the unit will
not be installed securely and may spring out.
• Make sure the 4 catches on the trim ring  are properly
engaged in the slots of the mounting sleeve .
Mounting the unit in a Japanese car
You may not be able to install this unit in some
Japanese cars. In such a case, consult your Sony
dealer.

Bracket
Parts supplied with
your car
When mounting this unit to the preinstalled
brackets of your car, use the mounting screws  in
the appropriate screw holes based on your car:
T for TOYOTA and N for NISSAN.
in)
4
Note
To prevent a malfunction, install only with the mounting
screws .

To the dashboard/center console
Bracket
