Beamz LED FlatPAR-186x10mm Notice D'utilisation page 7

Ne jetez pas les produits électriques dans la poubelle domestique. Déposez-les dans une déchetterie.
Demandez conseil aux autorités locales ou à votre revendeur.
INSTALLATION
Attention:

The installation of the fixture has to be built and constructed in a way that it can hold 10 times the weight for 1 hour
without any harming deformation.

The installation must always be secured with a secondary safety attachment, e.g. an appropriate catch net. This
secondary safety attachment must be constructed in a way that no part of the installation can fall down if the main
attachment fails.

Make sure the area below the installation place is free from unwanted persons during rigging, de-rigging and servicing.

The operator has to make sure that safety-relating and machine-technical installations are approved by an expert
before taking into operation for the first time and after changes before taking into operation another time.

The operator has to make sure that safety-relating and machine-technical installations are approved by a skilled
person once a year.

The fixture should be installed in the position where persons cannot reach and where persons may walk by or be
seated.
POWERSUPPLY
On the label on the backside of the light effect is indicated on this type of power supply must be connected. Check that
the mains voltage corresponds to this, all other voltages than specified, the light effect can be irreparably damaged. The
light effect must also be directly connected to the mains and may be used. No dimmer or adjustable power supply.
CAUTION: Please consider the respective national norms during the
installation! The installation must only be carried out by
an authorized employee or dealers!
CAUTION: When installing the device, make sure there is no highly
in inflammable material (decoration articles, etc.) in
between a distance of min o.5 meter.