Names And Functions Of Parts; Front Panel; Rear Panel; Preparation - Tascam VL-S3 Mode D'emploi

Names and functions of parts

Front panel

Same for both active and passive units
1 Tweeter
2 Woofer

Rear panel

Active unit
Passive unit
3 Bass reflex port
4 Stereo mini input jack
5 RCA pin input jacks
6 Speaker terminal (OUTPUT TO RIGHT)
Connect to passive unit.
7 VOLUME knob
8 Standby/On switch/indicator
9 DC IN 15V connector
0 Speaker terminal (INPUT FROM LEFT)
Connect to active unit.

Preparation

Precautions before making connec-
tions
• When unpacking the speaker units, do not hold
them by their tweeters or woofers.
• Connect signal cables and power cords so that
they will not become caught on anything.
• Before turning the built-in amplifier on,
minimize the volume of the input signal. Turning
it on while inputting a loud signal could damage
the speaker.
• Do not continuously use it for a long time at a
loud volume. Doing so could harm your hearing.
• Use power cords, power outlets, audio signal
cables and connectors that are undamaged and
free of wiring shorts and other defects.
• Set the power switch to STANDBY before
connecting the power cord.
• Do not input signals other than audio signals.
• Before connecting an audio signal to this unit,
confirm that the level of the input signal is
minimized and the power switch of the built-in
power amplifier is set to STANDBY.
• Always use the correct polarity.

Connections

1. Set the power switch to STANDBY.
2. Connect the included AC adapter (PS-P1524E) to
the speaker and then to the power supply.
3. Use the included connection cable (RCA–6.3mm
(1/4") standard TS jack) to connect the input
jack(s) of the active unit to the output device.
4. Use the included speaker cable to connect the
output terminal of the active unit to the input
terminal of the passive unit.
7
TASCAM VL-S3