Operation - EuroLite NX-150 Mode D'emploi

OPERATION

Connect the remote control with the Remote Control-socket. Switch the device on via the power switch.
LCD-Display
After a certain warm-up time, the device is ready to operate. When the machine is ready for fogging, the
display shows "OK" below the display line HEAT. By pressing the Output-button on the remote control the
smoke emission starts. It may happen that the the display below the line HEAT flashes. In this case the
device is heating up again and will be ready to operate in approx. 1-2 min. This process guarantees an
appropriate vaporization temperature and the best smoke emission possible. The temperature is regulated
by a high quality thermostat.
The remote control's interface allows the operator to customize fog machine functions by adjusting fogging
duration, interval and volume. Its LCD displays current operating parameters, which are automatically stored
in non-volatile memory, allowing the machine to be powered down without losing function settings.
Instructions below:
Description of the functions
After the machine starts heating up, the display below HEAT flashes. When the machine is ready for fogging,
the display shows "OK".
Via the Function key, you can move in the menu. Press the Function-key until the value of the desired
function starts flashing. Via the Up/Down-buttons, you can adjust the desired function values or change the
selection. In this way, you can adjust the functions of the smoke-machine the best way to the requirements
of the user. The individual functions are desribed in the following.
Description of the elements:
(1) LCD-display
(2) Up-button
(3) Function-button
(4) Down-button
(5) Timer-button
(6) Output-button
(7) Continuous-button
20/46 00020505.DOC, Version 1.1