Installation; General; Connection - ETNA RA345BEI Mode D'emploi

INSTALLATION

General

Connection

EN 10
This appliance must be connected to the mains by a recognized
installer who is familiar with and works in accordance with the
applicable safety regulations. This appliance meets the requirements of
European regulations.
Important information:
• The lowest part of the cooker hood must be at least 65 cm above
the cooking surface of the hob.
• Take account of local regulations governing the ventilation of gas
appliances.
• Before drilling holes, check to make sure that there are no wires in
the area.
• The installation material supplied with this cooker hood is suitable
for fastening to concrete and reinforced concrete ceilings.
Electrical connections
This appliance must be plugged into an earthed wall socket.
Check to make sure that the voltage specified on the type plate
matches the mains voltage. The appliance must be connected to the
mains as follows:
BROWN = L (live)
BLUE = N (neutral)
GREEN/YELLOW = Earth
Note:
When you wish to make a fixed connection to the mains, you must
make sure that a multipolar switch with a break contact distance of
at least 3 mm is fitted in the power cable.