Table des Matières
Publicité
794 Basic Titrino
3.2.2.6.
Mode.Def.SiloCalc.Assign.C24
Mode.Def.SiloCalc.Assign.C25
Mode.Def.SiloCalc.MatchId
.Assign.C2X: Assignment to store results in the silo as C2X.
.MatchId:
Indication which sample identification(s) have to match so that
the results can be combined.
3.2.2.7.
Mode.Def.ComVar.C30
Mode.Def.ComVar.C31
etc., up to .C39
Assignment of common variables.
The values of the common variables are to be found in &Config.ComVar. They
can be viewed and entered there, see 3.2.2.58.
3.2.2.8.
Mode.Def.Report.Assign
DET: full, short, mplist, curve, derive comb, scalc full, scalc srt,
calc, param, calib, ff
MET: full, short, mplist, curve, scalc full, scalc srt,
calc, param, calib, ff
SET, MEAS, CAL:full, short, scalc full, scalc srt, calc, param, calib, ff
TIP:
full, short, scalc full, scalc srt, calc, param, ff
Definition of the report sequence, which is outputted automatically at the end
of the determination. Entries of more than one block have to be separated with
";".
3.2.2.9.
Mode.Def.Mean.1.Assign
Mode.Def.Mean.2.Assign
etc., up to .9
Assignment of the statistics calculations. Valid assignments are a requirement
for statistics calculations. In addition, the statistics calculation must be
switched on, see 3.2.2.23. Rules for statistics calculations see page 55.
3.2.2.10. Mode.Def.TempVar.C70
etc. up to .C79
Assignment of temporary variables in a submethod for calculations in TIP.
3.2.2.11. Mode.CFmla
Mode.CFmla.1.Value
Mode.CFmla.2.Value
etc., up to .19
Calculation constants specific to a method. Stored in the method memory of
the Titrino. Operands specific to the sample (3.2.2.60 and 3.2.2.61) and val-
ues of common variables (3.2.2.58) on the other hand are not stored with the
methods.
3.2.2.12. Mode.Parameter.TitrPara.MptDensity
Mode.Parameter.TitrPara.MinIncr
3.2 Remote control commands
RSX, EPX, CXX
RSX, EPX, CXX
id1, id1&2, all, OFF
RSX, MNX, EPX, CXX
RS1, RSX, EPX, CXX
RSX, EPX, CXX
0...±999 999
0...10.0...999.9
0...4...9
103
Publicité
Table des Matières
