Toto YT800 Manuel D'installation Et D'utilisation page 5

7) Use the screws provided to mount
the push plate to the actuator.
8) Use the screws provided to
mount the flush panel to the flush
mechanism.
NO TE: If the wall thickness is within
45mm, break the connecting
rods (both red & blue) at B
section.
9) Screw the connecting rods
(matching colors) to the flush
mechanism until 18mm of the rods
is shown.
10) Repeat the process in part 6 in
reverse to install the buttons
back.
11) Press the tabs with your fingers to
snap the buttons in. Do not use a
screw driver in this operation.
12) Flush the toilet a few times for
each buttons, waiting about 30
sec. between each flush.
Installation Procedure (continued)
m
m
1 8
5
A
B
C
45 mm (B)