TDK-Lambda CUS200LD Manuel D'installation page 13

Instruction Manual
BEFORE USING THE POWER SUPPLY UNIT
Be sure to read this instruction manual thoroughly before using this product. Pay attention to all cautions and warnings before
using this product. Incorrect usage could lead to an electrical shock, damage to the unit or a fire hazard.
DANGER
Never use this product in locations where flammable gas or ignitable substances are present. There are risks of igniting these
substances and exploding by an arcing.
WARNING
Do not touch this product or its internal components while circuit in operation, or shortly after shutdown. There may be high
voltage or high temperature present and you may receive an electric shock or burn.
While this product is operating, keep your hands and face away from it as you may be injured by an unexpected situation.
Do not make unauthorized changes to this product, otherwise you may receive an electric shock and void your warranty.
Do not drop or insert anything into this product. It might cause a failure, fire and electric shock.
Do not use this product under unusual condition such as emission of smoke or abnormal smell and sound etc.
It might lead to fire and electric shock. In such cases, please contact us. Do not attempt repair by yourself, as it is dangerous for
the user.
Do not operate these products in the presence of condensation. It might lead fire and electric shock.
CAUTION
This power supply is designed and manufactured for use within an end product such that it is accessible to
SERVICE ENGINEERS only.
Confirm connections to input/output terminals are correct as indicated in the instruction manual before switching on.
Input voltage, Output current, Output power, ambient temperature and ambient humidity should be kept within specifications,
otherwise the product will be damaged.
Do not operate and store this product in an environment where condensation might occur. In such case, waterproof treatment is
necessary.
Do not use this product in environment with a strong electromagnetic field, corrosive gas or conductive substances.
For applications, which require very high reliability (Nuclear related equipment, medical equipment, traffic control equipment, etc.),
it is necessary to provide a fail-safe mechanism in the end equipment.
Do not inject abnormal voltages into the output or signal of this product. The injection of reverse voltage or over voltage
exceeding nominal output voltage into the output or signal terminals might cause damage to internal components.
Never operate the product under over current or short-circuit conditions, or outside its specified Input Voltage Range.
Insulation failure, smoking, burning or other damage may occur.
This product contains a printed circuit board utilizing surface mounted devices.
PCB stress such as bending, twisting etc. could cause damage. Therefore, please handle with care.
This product has used Power Thermistor to protect the circuit from Inrush Current. Frequent repetition of input on/off might
cause damage to internal components because of generating surge current.
The information in this document is subject to change without prior notice. Please refer to the latest version of the data sheet,
etc., for the most up-to date specifications of the product.
No part of this document may be copied or reproduced in any form without prior written consent of TDK-Lambda.
Note : CE MARKING
CE Marking when applied to a product covered by this handbook indicates compliance with the low voltage directive.
CUS200LD Series
<Page> 1/9
TDK-Lambda
CUS200LD
INSTRUCTION MANUAL
CA850-04-01A