Publicité
ZWS300BAF
④
③
②
①
⑤
① L : AC Input terminal Live line (Fuse in line.)
② N : AC Input terminal Neutral line
: Earth ( ) Terminal
③
④ Mounting hole (hole diameter : φ3.5mm)
These holes are connected to
Must be connected to Chassis (Conductor) of the equipment by metal spacer.
The mounting surface of the spacer should be within Maxφ8mm.
⑤ Mounting hole (hole diameter : φ3.5mm)
These holes are not connected to
⑥ + : + Output Terminal
⑦ - : - Output Terminal
⑧ V.ADJ : Output voltage adjust trimmer. The output voltage rises when a trimmer is turned clockwise.
⑨ ON/OFF Control Terminal (Option model "/R" : Only for ZWS100BAF, ZWS150BAF, ZWS300BAF)
3. Terminal Connection Method
Pay attention to the input wiring. If it is connected to wrong terminal, the power supply will be damaged.
·
Input must be off when making connections.
·
Connect
terminal of input connector to protective earth terminal.
·
The output load line and input line shall be separated to improve noise sensitivity.
·
Do not apply stress to PCB, when connecting or removing connector.
·
Use input/output connector (housing) specified by the table below.
·
Use the terminal pin SVH-21T-P1.1 or BVH-21T-P1.1, when output current per connector pin is 5A or less.
·
Use the terminal pin SVH-41T-P1.1 or BVH-41T-P1.1, when output current per connector pin is 7A or less.
·
Use recommended crimping tool. Connector is not included with this product. (Refer to the following page)
ZWS50BAF
COMPONENT
INPUT
CN1
INPUT
terminal of CN1.
terminal of CN1.
SIDE
CN51
OUTPUT
VR51
COMPONENT SIDE
⑤
ZWS75BAF
INPUT
CN1
LOAD
-2-
TDK-Lambda
ZWS-BAF Series
Instruction Manual
OUTPUT
COMPONENT
SIDE
CN51
OUTPUT
VR51
④
⑦
⑥
⑨
⑧
⑤
LOAD
Publicité
