Acc-Smart AQUANEST-M8 Manuel D'utilisation page 9

Wi-Fi Control Mode
Download the APP
◆ Use the phone to scan the two-dimensional code below for download and install the APP <IOS or
Android >.
◆ Please Search " AQUANEST " in Google Play Store or Apple APP Store , Download and install
it.
Wi-Fi Operation Mode Instruction
The Wi-Fi of the lamp supports two kinds of connection modes, AP Mode and STA mode.
Wi-Fi AP Mode The lamp itself will send out AQUANEST-**** Wi-Fi signal (for the Wi-Fi ID please
see the label of the lamp body), and you smart phone can be directly connected to this Wi-Fi signal
so as to control the lamp. This mode in applicable to independent control of single lamp.
Method for Configuring Wi-Fi AP Mode
◆ Operate on lamp panel, enter "4.WiFi Config"—"1.AP mode, select "Yes", and press OK key for
confirmation, after the lamp restarts, the indicator light is on and goes out after 3senconds,then it
switches to Wi-Fi AP mode.
4. WiFi Config
5. Timer
定时
◆ Get into WLAN page of your phone, Choosing the
AQUANEST-**** Wi-Fi signal, type down the password
" 12345678 " , The light will connected with your phone .
Open AQUANEST APP, the lamp 's Wi-Fi ID will show on
Wi-Fi page of APP, press "Enter" get into home page to
control the lamp .
1. Wi-Fi AP Mode
2. Wi-Fi STA Mode
定时
Set to AP Mode
YES NO
定时