Publicité
Les langues disponibles
Les langues disponibles
Press the switch
to turn on the
LED light
Turn the adjustment dial to adjust
the brightness
3.
Open the stand
Open the stand to stabilize the work light.
(Fig. 11)
Open
4.
Securing to a tripod
The work light can be secured to a tripod using
the screw hole for tripod (5/8-UNC).
If the screw of the tripod is less than 20 mm
long, attach the included adapter to the tripod
before fastening the work light. (Fig. 12)
Adapter
Tripod
Fig. 10
Stand
Fig. 11
Less than
20 mm long
Tripod
Fig. 12
NOTE
○
Use a tripod that can support a load of 5.5 kg or
more.
○
When using a tripod, ensure that it is stable so
that it does not fall over.
5.
How to recharge USB device
WARNING
○
Prior to use, check the connecting USB
cable for any defect or damage.
Using a defective or damaged USB cable
can cause smoke emission or ignition.
○
When the product is not being used, cover
the USB port with the rubber cover.
Buildup of dust etc. in the USB port can
cause smoke emission or ignition.
Open the rubber cover of the USB port, and fi rmly
plug in a commercially available USB cable into the
USB port. (Fig. 13)
USB port
Rubber cover
NOTE
○
Charging is possible from either the battery or
the AC cord.
When both are used at the same time, the AC
cord's power source takes priority.
○
When using the battery as the work light's
power supply, ensure that the battery is
suffi ciently charged. If the battery's charge
capacity becomes low, the work light cannot
charge USB devices.
○
The charging time diff ers depending on the
type of USB device being used.
○
Do not use for any purpose other than charging
a USB device.
○
It may not be possible to charge some types of
USB devices.
English
USB cable
Fig. 13
15
Publicité
