Mounting Precautions - Sharp PN-L805H Manuel D'installation

• This product is for use indoors.
• A mounting bracket compliant with VESA specifications is
required.
• Since the monitor is heavy, consult your dealer before
installing, removing or moving the monitor.
• Mounting the monitor on the wall requires special expertise
and the work must be performed by an authorized SHARP
dealer. You should never attempt to perform any of this
work yourself. Our company will bear no responsibility
for accidents or injuries caused by improper mounting or
mishandling.
• Use the monitor with the surface perpendicular to a level
surface. If necessary, the monitor may be tilted up to 20
degrees upward.
• When moving this monitor, be sure to hold it with the
handles, the unit sides, the unit bottom or the unit top. Do
not grasp the screen, unit corner, tray, speaker, or speaker
cover. This may cause product damage, failure, or injury.
• This monitor should be used at an ambient temperature
between 41°F (5°C) and 95°F (35°C).
• Be careful of high temperatures in the surrounding area.
If it is difficult to provide sufficient space for any reason
such as the installation of the monitor inside a housing, or
if the ambient temperature may be outside of the range
of 41°F (5°C) to 95°F (35°C), install a fan or take other
measures to keep the ambient temperature within the
required range.
• Temperature condition may change when using the monitor
together with the optional equipments recommended by
SHARP. In such cases, please check the temperature
condition specified by the optional equipments.
• Do not block any ventilation openings. If the temperature
inside the monitor rises, this could lead to a malfunction.
• Do not place the monitor on a device which generates heat.
• Adhere to the following when installing the monitor in its
portrait orientation. Failing to adhere to the following may
cause malfunctions.
- Install the monitor such that the power LED is located on
the bottom side.
- Set the PORTRAIT/LANDSCAPE INSTALL on the
MONITOR menu to PORTRAIT.
(See OPERATION MANUAL.)
- Be sure to clamp the power cord (supplied) onto the cable
clamp attachment using the supplied cable clamp. When
clamping the power cord, take care not to stress the terminal
of the power cord. Do not bend the power cord excessively.
Cable clamp
Cable clamp
attachment
Power cord (Supplied)
4
E

MOUNTING PRECAUTIONS

Power LED
• Use the supplied vertical sticker when you install the
monitor in portrait orientation.
Flat installation
• When using this monitor laying flat on a surface (when
the monitor is tilted more than 20 degrees upward from
the perpendicular in relation to a level surface), consult an
authorized SHARP dealer because there are some specific
mounting conditions.
Adhere to the following. Failing to adhere to the following
may cause malfunctions.
- Set HORIZONTAL INSTALLATION in the MONITOR
menu to FACE UP. (See OPERATION MANUAL.)
- Use this monitor at the ambient temperature between
41°F (5°C) and 86°F (30°C). Provide 7-7/8 inch (200
mm) or more space between the monitor and the floor
or other mounting surfaces and surrounding objects to
prevent heat from accumulating inside. If it is difficult to
provide sufficient space or if the ambient temperature
may be outside of the range of 41°F (5°C) to 86°F (30°C),
install a fan or take other measures to keep the ambient
temperature within the required range.
7-7/8 [200]
7-7/8
[200]
7-7/8 [200]
- Do not press hard on the LCD panel or otherwise subject
it to impacts.
Cover SHARP logo
Logo
Unit: inch [mm]
7-7/8
[200]
7-7/8
[200]