Instructions For Periodic Maintenance; Service, Spare Parts And Guarantee - Makita DPC 6400 DPC 6401 Manuel D'instructions Et De Sécurité

Instructions for periodic maintenance

To ensure long life, prevent damage and ensure the full functioning of the safety features the following maintenance must be
performed regularly. Guarantee claims can be recognized only if this work is performed regularly and properly. Failure to perform
the prescribed maintenance work can lead to accidents! Users of the Power Cut must not perform any maintenance work not
described in this Instruction Manual. All such work must be carried out by a MAKITA service centre.
General
Before each start
Every day
Every week
Every 3 months
Storage

Service, spare parts and guarantee

Maintenance and repair
The maintenance and repair of modern cutoff saws and their safety-related components requires qualified technical training and a
workshop equipped with special tools and testing devices.
We therefore recommend that you consult a MAKITA service centre for all work not described in this instruction manual.
The MAKITA service centres have all the necessary equipment and skilled and experienced personnel, who can work out cost-effective
solutions and advise you in all matters.
Please contact your nearest service centre (list enclosed) or the general trading company or importer (see last page), who will gladly
provide you with the address of your nearest MAKITA service centre.
Spare parts
Reliable long-term operation, as well as the safety of your Power Cut, depend among other things on the quality of the spare parts used.
Use only original MAKITA parts, marked
Only original parts are from the same production line as the original unit and therefore ensure the highest possible quality of materials,
dimensions, functioning and safety.
Only original spare parts and accessories guarantee the highest quality in material, dimensions, functioning and safety.
Original spare parts and accessories can be obtained from your local dealer. He will also have the spare part lists to determine the
required spare part numbers, and will be constantly informed about the latest improvements and spare part innovations.
Please bear in mind that if parts other than original MAKITA spare parts are used, this will automatically invalidate the MAKITA product
guarantee.
We will furthermore not accept any liability damages arising from the use of non-MAKITA spare parts.
26
Entire Power Cut
Cutting disc
Clutch
Protection hood
Cutting disc
V-belt
Combination switch,
Safety locking button,
Throttle lever
Fuel tank cap
Air filter
Idle speed
Fan housing
Starter cable
V-belt
Paper cartridge
Spark plug
Muffler
Suction head
Fuel tank
Entire Power Cut
Cutting disc
Fuel tank
Carburetor
Clean exterior, check for damage. In case of damage,
have repaired by a qualified service centre immediately
Inspect regularly for damage and wear.
Have inspected at a service center.
Clean
Inspect for damage and make sure the cutting wheel is
right for the job
Check V-belt tension
(note: tension gauge must be purchased separately)
Functional check
Functional check
Functional check
Check for tightness
Clean
Check (cutting disc must not turn on idle)
Clean to ensure proper air cooling
Check for damage
Check V-belt tension, inspect for damage and wear
Clean
Check and replace if necessary
Check tightness of mounting, clean spark arrester screen
Replace
Clean
Clean exterior, check for damage. In case of damage,
have repaired by a qualified service centre immediately
Remove and clean
Empty and clean
Run empty
Page
6
19
6
13
15
19
17
11
21
18
20
20-21
11, 24
21
12