Options; Before First Use - AEG FAVORIT 88009I Notice D'utilisation

24 www.aeg.com
Information for test institutes
For all the necessary information for test performance. send an email to:
info.test@dishwasher-production.com
Write down the product number (PNC) that is on the rating plate.

5. OPTIONS

Activate or deactivate the op-
tions before the start of a pro-
gramme. You cannot activate or
deactivate the options while a
programme operates.
If one or more options are set,
make sure that the related indi-
cators are on before the pro-
gramme starts.
5.1 Multitab
Activate this option only when you use
the combi detergent tablets.
This option deactivates the flow of rinse
aid and salt. The related indicators are
off.
The programme duration can increase.
• Press Option again and again until the
multitab indicator comes on.
• The option stays on until you deacti-
vate it. Press Option again and again
until the multitab indicator goes off.
If you stop to use the combi
detergent tablets, before you start to
use separately detergent, rinse aid
and dishwasher salt, do these steps:
1. Deactivate the multitab option.
2. Set the water softener to the highest
level.
3. Make sure that the salt container and
the rinse aid dispenser are full.
4. Start the shortest programme with a
rinsing phase, without detergent and
without dishes.

6. BEFORE FIRST USE

1. Make sure that the set level of the
water softener agrees with the water
hardness in your area. If not, adjust
5. Adjust the water softener to the wa-
ter hardness in your area.
6. Adjust the released quantity of rinse
aid.
5.2 ÖKO PLUS
This option decreases the temperature
in the drying phase. The energy con-
sumption decreases by 25%.
The dishes can be wet at the end of the
programme.
Press the ÖKO PLUS touchpad:
• If the option is applicable to the pro-
gramme, the related indicator comes
on.
• If the option is not applicable to the
programme, the related indicator
flashes for some seconds and then
stays off.
5.3 ExtraHygiene
This option gives better results for the
hygiene. During the rinsing phase, the
temperature stays at 70 °C for 10 to 14
minutes.
Press the ExtraHygiene touchpad:
• If the option is applicable to the pro-
gramme, the related indicator comes
on.
• If the option is not applicable to the
programme, the related indicator
flashes for some seconds and then
stays off.
the water softener. Contact your local
water authority to know the water
hardness in your area.