Publicité
Les langues disponibles
Les langues disponibles
UP/DOWN button to select the
to left) or
Once the mode has been selected, press the ENTER button to setup, to go back to the
functions without any changes press the MENU button again. Hold and press the MENU
button for one second or wait for one minute to exit the menu mode.
5. How to control the fixture
You can operate the unit in two ways:
1. By master/slave built‐in preprogram function
2. By DMX controller
No need to turn the unit off when you change the DMX address, as new DMX address
setting will be affected at once. Each time you turn the unit on, it will show
display. After that the unit will be ready to receive DMX signal or run the built in programs.
4.1 Master/Slave Build in Preprogrammed Function
By linking the units in master/slave connection, the first unit will control the other units to
give an automatic, sound activated, synchronized light show. This function is good when you
want an instant show. You have to set the first unit in master mode
(Random show),
input jack will have nothing plugged into it, and its master LED will be constantly on and
sound LED will flash to the music. The other units will have to select
or
(2 light show) mode, Their DMX cables plugged into the DMX input jacks (daisy
chain) and the slave LED lights will be constantly on.
4.2 DMX Controller
Using a universal DMX controller to control the units, you have to set DMX address from 1 to
512 channel so that the units can receive DMX signal.
Press the MENU button up to when the
(normal, the projector lenses 8pcs LED will light up right to left) mode.
(Show 1) or ... Or
(the projector lenses 8pcs LED will light up right
is showing on the display. Press ENTER
19
and select
(Show 12) mode. Its DMX
(normal)
on the
Publicité
