About These Instructions; Initial Operation - Carrera 421 Mode D'emploi

CAUTION! Risk of material damage
Use the original accessories only.
The appliance can not intended to be operated while connec-
● ●
ted to a PC via the USB port.
Never place the shaver on hot surfaces (e.g. hob plates) or
● ●
near heat sources or open fire.
Do not cover the wall power supply to prevent overheating.
● ●
In order to avoid damages to the shaving foil, do not exert
● ●
excessive pressure on the shaving foil.
Do not use any harsh or abrasive cleaning agents.
● ●
Installation of a residual current appliance (FI/RCD) with a rated
● ●
residual operating current of no more than 30 mA is recom-
mended to provide additional protection.
Ask your electrician for advice. The installation should only be
carried out by a qualified electrician.
NOTE: We advise you not to use shaving gel, since this may cause the
shaving foil and cutting blades to stick to each other.

03. ABOUT THESE INSTRUCTIONS

Before using the shaver for the first time, read the
● ●
Instructions for Use carefully and ensure you comply with the safety
instructions!
The shaver should only be used as described in these instructions.
● ●
The manufacturer or dealer is not liable for damages arising from
any use contrary to the intended purpose.
Keep these instructions for reference.
● ●
If you pass the shaver on to someone else, please include these
● ●
instructions.
28 GB
Warnings in these instructions
If necessary, the following warnings will be used in these operating
instructions:
DANGER! High risk: Failure to observe this warning may result
in injury to life and limb.
WARNING! Moderate risk: Failure to observe this warning may
result in injury or serious material damage.
CAUTION: Low risk: Failure to observe this warning may result
in minor injury or material damage.
Symbol on the appliance: suitable for cleaning under an open
water tap.
DANGER! Detach the hand­held part from the supply cord
before cleaning it under running water.
NOTE: Circumstances and specifics that must be observed when
handling the appliance.

04. INITIAL OPERATION

Checking the shaver and scope of delivery
1. Remove the shaver from its packaging.
2. Check the delivery for completeness (see fig. A).
3. Check whether the shaver, the individual parts or the accessories
show any damages.
4. If the scope of delivery is incomplete or the shaver, the individual
parts or the accessories show any damages, do not use the shaver.
Contact the manufacturer via the service address stated on the war-
ranty card.
GB 29