Panasonic CS-XE9WKUAW Instructions D'utilisation page 7

To select Room Freeze Protection
RFP
• When selected, the unit will circulate the air in High mode for monitoring the temperature.
When the sensor detects the temperature drops below 46 °F / 8 °C the compressor/heat
pump operation begins, when the temperature reaches 50 °F / 10 °C, the compressor stops
and repeat this cycle.
To connect network
• For Wireless LAN Module operation setup, please refer to Setup Instructions Manual.
To set the timer
2 sets of ON and OFF timers are available to turn ON or OFF the unit at different preset time.
1 2
1 Select ON or OFF
timer
• Each time pressed:
(exit setting)
2 Set the time
3 Confirm
Note
POWERFUL
,
• Can be selected at the same time.
• Can be activated in all modes.
• Can be cancelled by pressing the
respective button again.
ACXF55-27111_FC1219-1.indb 7
3
Example:
OFF at 22:00
See "To learn more..." for details.
• To cancel ON or OFF timer, press
or to select respective
press .
• If timer is cancelled manually or due to
power failure, you can restore the timer
again by pressing
respective or then press
• The nearest timer setting will be displayed
and will activate in sequence.
• Timer operation is based on the clock set
in the remote control and repeats daily
once set. For clock setting, please refer to
Quick Guide.
FAN SPEED/
POWERFUL
, QUIET
• POWERFUL, QUIET and FAN SPEED
cannot be selected at the same time.
or then
or to select
.
11/21/2019 2:56:52 PM
7