Pkm 6090H Mode D'emploi page 23

2. Now connect the exhaust hose to the air-outlet
opening of the hood. Put the widened end of the
exhaust hose over the air-outlet. Start at the back
of the air-outlet then proceed from inside the
exhaust hose by installing it (use your thumbs)
on the air-outlet.
3. Place the suspension device on the wall. Select the position relevant to the
dimensions of the entire appliance. Mark the drillings with a pencil before.
4. Drill the holes
suspension device with the screws
and dowels.
5. Hang the hood on the fixed
suspension device.
6. Install the flat bar on the bottom chimney first, then on the wall. You can carry
out this step provisionally to mark the drillings of the wall mounting and drill
the relevant holes.
Chimney
7. Place the top and bottom chimney on the hood and fix the bottom one on it
(look at the drawing connect chimney to hood).
8. Fix the chimney-installation bracket below the ceiling on the wall using the
screws and dowels.
Screw chimney ↔
bracket
and fix the
Wall
23
Chimney
Screw chimney
bracket
↔