Changing The Floor Tool Blades - Nacecare TTV - 4555 Mode D'emploi

!
ALWAYS ENSURE THAT THE MACHINE IS SWITCHED OFF PRIOR TO ANY
REMOVE THE KEY PRIOR TO ANY MAINTENCANCE OPERATION.
The floor-tool
Fig.42
To clean the floor-tool, remove securing-pin and pull-free from the holder (see Fig 42).
Rinse the floor-tool assembly with clean water and refit.
Periodically the floor-tool blades should be examined and checked for wear and damage.
The blade removal is easy. Simply start by removing the four retaining pins (Fig 43), turn the
floor-tool over and separate the blade carrier from the body (Fig 44). Peel away the blades from their locating lugs
(Fig 45) and examine or renew as required.
Replacement is a reversal of the removal process.
Floor-tool overview
1. Floor-tool main body
2. Rear blade
3. Blade carrier
4. Front blade (slotted)
5. Retaining pins x 4

Changing the Floor Tool Blades

MAINTENANCE USING THE MASTER CONTROL ON/OFF KEY.
Fig.44
1
2
3
4
5
20
Fig.43
Fig.45
!