Filling The Clean-Water Tank; Fill Level Indicator - Nacecare TTV - 4555 Mode D'emploi

Filling the clean water tank
The TTV-4555 is equipped with a large capacity 60 litre clean-water tank allowing, for large areas to be covered in
a single fill.
To fill the clean-water tank, extend the hose located to the rear of the machine in the centre of the removable filler cap,
(Fig 17). Pull out hose, (Fig 18). Open the stopper (Fig 19) and place hose under water tap, or use a hose to
commence filling (Fig 20).
Or the tank can be filled by unscrewing the filler cap and using a bucket or similar container (Fig 21).
Note: Great care must be taken to ensure that contaminants (leaves, hair, dirt, etc.) are not allowed to enter the
clean-water tank during the filling process. If using a bucket or similar, ensure it is always clean and free from debris.
Fig 22
Machine Set Up
Fig 17
Fig.19
Fill-level indicator
The water level in the
clean water tank can
be measured using the
scale on the left rear
side of the machine
(Fig 22).
The clean water
bottom tank holds 60
litres.
Fig 18
Fig.20
12
Fig.21