Perel LEDA200 NW-B Série Mode D'emploi page 6

5.4 Mounting the lamp
1. This luminaire does not have a built-in device to disconnect it from the
electric mains. Make sure to electrically isolate the luminaire before
installation or maintenance activities are performed.
2. Use the mounting bracket to determine the location of the mounting holes.
3. Drill the holes and secure the bracket using screws and wall plugs.
4. Connect the power cable to the screw terminal. Make sure there is no
strain on the cable; leave sufficient slack.
Warning: if the power cable is damaged, it must be replaced by the
manufacturer, his service agent, or a similar qualified person in order to
avoid any hazard.
5. To point the lamp in the desired direction: loosen the hinges using a
screwdriver.
6. Tilt the lamp in the desired angle and tighten the hinges.
6. Cleaning and Maintenance
 This luminaire does not have a built-in device to disconnect it from the
electric mains. Make sure to electrically isolate the luminaire before
installation or maintenance activities are performed.
 All screws should be tight and free of corrosion.
 The housing, the visible parts, the mounting supports and the
installation location (e.g. ceiling, suspension, trussing) should not be
deformed, modified or tampered with; e.g. do not drill extra holes in
mounting supports, do not change the location of the connections...
 The electric power supply cables must not show any damage. Have a
qualified technician maintain the device.
 If the protective glass is damaged, disconnect the lamp immediately
from the mains. Have it repaired immediately by a qualified technician.
Do not use the lamp with a cracked or broken protective glass.
 Wipe the device regularly with a moist, lint-free cloth. Do not use
alcohol or solvents.
 There are no user-serviceable parts.
 Contact your dealer for spare parts if necessary.
V. 02 – 16/11/2015
LEDA200xNW-B
N = neutral, blue
L = line, brown
6 ©Velleman nv