Perel VTBAL104 Mode D'emploi page 4

4. Description
Refer to the illustrations on page 2 of this manual.
1
2
5. Operation
5.1 General Operation
1. Place the scale on a solid, level and non-slippery surface.
2. Rotate the wheel a couple of times to switch on the scale. The scale is ready-to-use
when the display shows 0.
3. Place the item to be weighed or the tare item (see below) in the middle of the
weighing platform.
4. The weight is displayed.
5.2 Tare Function
1. Place the tare item in the middle of the weighing platform.
2. Press the tare button to enter the tare function.
3. Place the item to be weighed in the tare item.
4. The weight is displayed.
5. Press the tare button again to reset the scale.
5.3 Unit Conversion
Hold the unit button pressed for 3 seconds until the desired weighing unit is displayed.
5.4 Negative Value
The display shows a negative value if a (tare) weight has been removed from the scale.
Press the on-off/zero/tare button to clear the display.
V. 03 – 19/07/2019
rotating wheel
weight unit
VTBAL104
3
4
tare
©Velleman nv