DeWalt DCF680 Guide D'utilisation page 14

DCF681
Insert the appropriate hex shank bit into the magnetic bit holder (G).
Refer to To Operate for instructions.
Operation as a Deburring Tool (Fig. 2, 7)
DCF681
WARNING: Always keep hands and clothing away from the cutting
area of the tool.
WARNING: Only retract the cone by pressing against a pipe end.
Do not lock the cone in the retracted position.
NOTICE: When deburring it is recommended to leave a hex bit in the
magnetic holder. Metal chips and shavings caused by deburring can
be picked up by the magnet in the holder.
1. Activate the tool by the pressing the trigger and rotating the tool
in the desired direction.
2. Slowly feed into pipe and press cone against burred pipe end.
NOTE: Tool should be active before engaging with the pipe.
3. With tool activley rotating, firmly depress cone against the pipe,
engaging the cutter with pipe end. Allow multiple rotations to fully
deburr the pipe end.
WARNING: Tool can stall, causing a sudden twist. To reduce the
risk of injury, always use proper hand position as shown, and always
hold securely in anticipation of the tool cutter binding.
4. Once pipe end is deburred, pull the tool out of pipe and then
release the trigger.
WARNING: Before and after each use, inspect the cone for proper
closing. Do not operate the tool if the cone does not move freely and
close instantly.
FIG. 7
MAINTENANCE
WARNING: To reduce the risk of serious personal injury,
turn tool off and remove the battery pack before making any
adjustments or removing/installing attachments or accessories.
An accidental start-up can cause injury.
Cleaning
WARNING: Blow dirt and dust off of tool and cone/cutter area
(DCF681) with clean, dry air at least once a week. To minimize the
risk of eye injury, always wear ANSI Z87.1 approved eye protection
when performing this.
WARNING: Never use solvents or other harsh chemicals for
cleaning the non-metallic parts of the tool. These chemicals may
weaken the plastic materials used in these parts. Use a cloth
dampened only with water and mild soap. Never let any liquid get
inside the tool; never immerse any part of the tool into a liquid.
CHARGER CLEANING INSTRUCTIONS
WARNING: Shock hazard. Disconnect the charger from the AC
outlet before cleaning. Dirt and grease may be removed from the
exterior of the charger using a cloth or soft non-metallic brush. Do not
use water or any cleaning solutions.
12