DeWalt DCF680 Guide D'utilisation page 12

Two-Position Screwdriver (Fig. 3)
DCF680
To convert the tool to an angled
screwdriver push on the release
button (D) and rotate the top portion
of the tool as shown.
Torque Adjustment
Collar (Fig. 3)
DCF680
The torque adjustment collar (I) is
marked with numbers and a 'MAX'
symbol. The higher the number on
the collar, the higher the torque. To
lock the clutch for fastening operations, move to the 'MAX' position.
Failure to do this will allow the clutch to slip while attempting to fasten.
Quick Release Chuck (Fig. 2)
DCF680, DCF682
NOTE: The chuck accepts 1/4" (6.4 mm) hex accessories only.
To install a bit, insert the bit into the chuck until the clip locks it in place.
To remove a bit, pull the chuck (H) forward. Remove the bit and
release the chuck.
Magnetic Bit Holder (Fig. 2)
DCF681
NOTE: The holder accepts 1/4" (6.4 mm) hex accessories only.
To install a bit, insert the bit into the holder until the magnet holds it
in place.
To remove a bit, pull it out of the holder.
FIG. 3
1
3
I
D
10
OPERATION
WARNING: To reduce the risk of serious personal injury,
turn tool off and remove the battery pack before making any
adjustments or removing/installing attachments or accessories.
An accidental start-up can cause injury.
CAUTION: To avoid accidental activation during transport or
storage, put the lock-off switch (Fig. 2, B) in the up, locked-off position.
NOTICE: Do not use screwdriver as a pry bar.
Installing and Removing the Battery Pack
(Fig. 4)
NOTE: For best results, make sure your battery
pack is fully charged.
To install the battery pack (F) into the tool handle,
align the battery pack with the recess in the tool's
handle and slide it into the handle until the battery
pack is firmly seated in the tool and ensure that it
does not disengage.
To remove the battery pack from the tool, press the
release button (E) and firmly pull the battery pack
out of the tool handle. Insert it into the charger as
described in the charger section of this manual.
BATTERY FUEL GAUGE (FIG. 5)
The D WALT cordless screwdriver has
E
a fuel gauge which consists of three
green LED lights that indicate the level
of charge remaining in the battery pack.
To actuate the fuel gauge, press and
hold the motion control activation
trigger (A). A combination of the
three green LED lights will illuminate
designating the level of charge left.
FIG. 4
F
E
FIG. 5
A