DeWalt DCF680 Guide D'utilisation page 13

When the level of charge in the battery is below the usable limit, the
fuel gauge will not illuminate and the battery will need to be recharged.
NOTE: The fuel gauge is only an indication of the charge left on the
battery pack. It does not indicate tool functionality and is subject to
variation based on product components, temperature and end-user
application.
For more information regarding the battery fuel gauge, please call
1-800-4-D WALT (1-800-433-9258) or visit our website www.dewalt.
E
com.
To Operate
Your screwdriver uses gyroscopic technology to sense your hand
motion. To operate, press in the motion control activation trigger
and turn your hand in the direction that you want the screwdriver to
operate.
SETTING INITIAL STARTING POINT
1. Grasp the screwdriver as shown in Figure 6.
2. Press and hold in the motion control activation trigger.
3. When the LED illuminates the tool is ready for use.
4. To reset initial starting point first release the motion control
activation trigger. Move tool to new position, then press and hold
in the motion control activation trigger.
OPERATING IN FORWARD DIRECTION
1. Grasp the screwdriver as shown in Figure 6.
2. Engage head of fastener with screwdriver accessory on work
piece. Follow instructions for setting initial starting point.
3. Rotate your hand to the right and the screwdriver will activate in
the forward direction.
OPERATING IN REVERSE DIRECTION
1. Grasp the screwdriver as shown in Figure 6.
2. Engage head of fastener with screwdriver accessory on work
piece. Follow instructions for setting initial starting point.
3. Rotate your hand to the left and the screwdriver will activate in the
reverse direction.
To turn the tool off, release the motion control activation trigger.
VARIABLE SPEED
• The spindle speed is dependent upon the speed that you rotate
your hand.
• The slower you rotate your hand, the slower the screwdriver turns.
• The faster you rotate your hand, the faster the screwdriver turns.
• If you wish to increase the spindle speed, rotate your hand further
in the same direction.
• If you wish to decrease the spindle speed, rotate your hand back
towards the initial starting point.
FIG. 6
Operation as a Screwdriver
DCF680, DCF682
Insert the appropriate hex shank bit into the chuck (H). Refer to To
Operate for instructions. To determine the proper position of the
torque adjustment collar (DCF680 only) make a few practice runs in
scrap or unseen areas.
11