GUTMANN VISUAL Mode D'emploi page 23

off the appliance. The intensive setting
automatically switches back to high fan
power after three minutes (setting 3).
Automatic after-run
Press the button with the clock symbol
to activate the after-run time. The ex-
tractor hood switches back from level 3
to level 1and runs for ~15 min. at this
setting before switching off.
Lighting
Press the button with the lighting symbol
to switch in the lighting. Press again to
switch off the lighting. The lighting is
dimmed by pressing and holding the
button. Press and hold the button again
to increase the brightness. The fan can
switch itself on automatically after a long
period of standalone operation of the
lighting. This overheating protection
function automatically switches the fan
off again.
Display grease filter cleaning
If the grease filter display lights up
(button on the right), the filter must be
cleaned. After cleaning the filter, press
and hold the right-hand button for at
least five seconds. The indicator lamp
goes out. The grease filter indicator is
activated after max. 15 operating hours
or every two weeks (even if no cooking
takes place during this time).
Cleaning and care
Cleaning the surfaces
Danger due to electric shock! Discon-
nect the extractor hood from the power
supply by pulling the plug out of the
socket or by switching off the fuse.
When cleaning, make sure that no water
penetrates the device. Regular cleaning
of the surface saves laborious removal
of stubborn contamination. Only use
conventional detergents or universal
cleaning agents suitable for cleaning
stainless steel/aluminium. Never use
abrasive cleaning agents or steel wool.
After cleaning the hood, treat the
stainless steel surfaces with a stainless
steel care product. Painted surfaces
should only be cleaned using a mild
detergent solution and a very soft cloth.
Only use a soft damp cloth to clean the
operating panel.
On hoods fitted with a panel below the
filter (edge extraction), grease deposits
occur at the edge of the panel. These
deposits occur for physical reasons and
are not due to a malfunction of the hood.
Please clean the panel underneath the
filter regularly to prevent the formation of
stubborn residues.
Cleaning and care instructions
When cleaning the grease filters, also
remove any grease deposits from the
accessible housing components. This
will prevent a fire hazard and maintain
an optimum range of functions. Use hot
soapy water or a mild window cleaning
agent to clean the hood. Do not scratch
off baked-on deposits. Soften them us-
ing a damp cloth. Do not use abrasive
agents or scouring pads.
Note: Do not use alcohol (spirits) on
plastic surfaces, as dull spots may re-
sult.
Caution: Ventilate the kitchen suffi-
ciently, no open flame.
Only clean the operating panel with a
soft damp cloth (mild detergent solu-
tion). Do not use stainless steel cleaners
for the sliding switch/pressure switch.
Stainless steel surfaces:
Use a mild and non-abrasive stainless
steel cleaning agent. Do not clean
stainless steel surfaces with abrasive
scouring pads or with cleaning agents
containing sand, soda, acid or chloride!
Clean in direction of polish only.
We recommend our stainless steel
cleaner no. 461731. See the enclosed
service booklet for the order address.
Aluminium, varnished and plastic
surfaces:
Use a soft micro fibre cloth. Do not use
dry cloths. Use a mild window-cleaning
agent. Do not use aggressive cleaning
agents or agents containing acid or lye!
Do not use scouring agents.
en
23