Important Safety Instructions For All Battery Packs - DeWalt DCR015 Guide D'utilisation

15. Apparatus shall not be exposed to dripping or splashing and no
objects filled with liquids, such as vases, shall be placed on the
apparatus
The lightning flash with arrow head within a triangle is intended
to tell the user that parts inside the product are a risk of electric
shock to persons.
The exclamation point within a triangle is intended to tell the user
that important operating and servicing instructions are in the
papers with the appliance.
This Class B digital apparatus complies with Canadian ICES-003.
NOTE: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to ratio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the
receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected
• Consult the dealer or an experienced radio/TV technician for
help.
NOTICE: Per FCC Part 15, changes or modifications to this
equipment not expressly approved by D
authority to operate this equipment.
WARNING: To reduce the risk of fire or electric shock, do not
expose this apparatus to rain or moisture. Use only in dry locations.
CAUTION: To prevent electric shock, match wide blade of plug to
wide slot fully insert.
• The label on your tool may include the following symbols. The
symbols and their definitions are as follows:
V ...............volts
Hz .............hertz
min ...........minutes
.................
.................(grounded) .................
.................(double insulated)
.../min .......per minute
IPM ...........impacts per minute
.................
SPM .........strokes per minute
.................
Important Safety Instructions for All
Battery Packs
When ordering replacement battery packs, be sure to include the
catalog number and voltage. Consult the chart at the end of this
manual for compatibility of chargers and battery packs.
The battery pack is not fully charged out of the carton. Before using
the battery pack and charger, read the safety instructions below and
then follow charging procedures outlined.
WALT could void your
E
2
A ............... amperes
W .............. watts
........direct current
.................
n o ............. no load speed
.............Class I Construction
n ............... rated speed
.............Class II Construction
BPM ......... beats per minute
RPM ......... revolutions per
.................
sfpm ......... surface feet per
.................
............ alternating current
............ alternating or direct
current
............. earthing terminal
.............. safety alert symbol
minute
minute